|
Post by dogfish7 on Sept 18, 2013 17:20:04 GMT -8
Fantastic detail!!
|
|
|
Post by brizio on Sept 20, 2013 7:54:02 GMT -8
Thank you Bruce! ere some more progress... Slowly slowly I do somethings on the model. The rear seat has an arm rest, but the kit did not offer it. Here the arm res and his space done. Fron arm rest and the little seat that goes between the front seat. The car was one of the few with 6 seats.
|
|
|
Post by dogfish7 on Sept 24, 2013 12:30:34 GMT -8
Very cool!
|
|
|
Post by brizio on Sept 25, 2013 15:51:14 GMT -8
|
|
|
Post by dogfish7 on Sept 26, 2013 7:54:50 GMT -8
Excellent work on the seats!
|
|
|
Post by garydavis on Sept 27, 2013 13:04:34 GMT -8
That's for sure!! Like Bruce said...EXCELLENT WORK.
|
|
|
Post by brizio on Oct 2, 2013 17:01:32 GMT -8
Thank you both!
|
|
|
Post by brizio on Oct 7, 2013 17:20:23 GMT -8
|
|
|
Post by dogfish7 on Oct 9, 2013 5:15:34 GMT -8
You have the whole show right now!
|
|
|
Post by brizio on Nov 1, 2013 8:26:03 GMT -8
Thank you Bruce!
|
|
|
Post by brizio on Nov 1, 2013 8:33:06 GMT -8
Here some more (finally) progress... Luckly I check before paint if the door works fine, because they required a lot of work. When closed they did not follow the body of the car, and when open they kind of fell down. Rear door fixed. Now it open and close better. Same work is required on the front door. Next thing to do is fill up the space for the front axle, so it looks more right. One of the two hinge for the hood. Here both glued in place. Next thing I'm working on are the door. I did not like the door panel, so I will rebuild it. First step is to glue the stock door panel on the door. Second remove the arm rests... Third , sandpaper all the panel and seal it with putty, pretty much this is the door without the door panel. Soon the rest...
|
|
|
Post by brizio on Nov 2, 2013 5:45:10 GMT -8
Here the interior... add the steering wheel. Hand painted the fake wood and add the chrome trim. The kit come with a big chrome piece for the center of the steering wheel, but did not match what the real car had. Here ta picture of the dashboard. The wood is handpainted,add the heat/cooling switch, air vents, key/key chain, gear stick, turn signal lever, etc...
|
|
|
Post by dogfish7 on Nov 7, 2013 15:00:20 GMT -8
Can't see it Briz!
|
|
|
Post by brizio on Nov 8, 2013 8:55:51 GMT -8
Me either... I will try to re-post them later.
|
|
|
Post by brizio on Nov 8, 2013 13:02:01 GMT -8
Some more progress... Hinge glued, some putty, ready for some sand paper for remove the inside design/panel, that they are wrong, they are suppose to be in negative not positive. This will help the hood to looks more realistic. Also the rear door need some sanding, those positive panels need to be gone and be made flat. Here hood and trunk doors done.
|
|